Topic List |
Page List:
1 |
---|---|
littlebro07 03/22/23 11:29:04 AM #1: |
Had two 3000mhz sticks, replaced with 3200mhz sticks, and went into the bios to change the speed to 3200. Is there something else I'm supposed to do? Switched it back to 3000 for now halp --- https://i.imgtc.com/MGGa6Os.gif ... Copied to Clipboard!
|
Jupiter 03/22/23 11:33:06 AM #2: |
I don't recall manually having to set the speed of RAM in the bios unless it was the XMP. But did you look at your motherboard's compatibility list for compatible RAM? Some just work better than others. --- Twitch: https://www.twitch.tv/kid_prodigy23 ... Copied to Clipboard!
|
littlebro07 03/22/23 11:35:34 AM #3: |
Jupiter posted... I don't recall manually having to set the speed of RAM in the bios unless it was the XMP. But did you look at your motherboard's compatibility list for compatible RAM? Some just work better than others. Yeah, says it should take the following: DDR4 2133, 2400, 2666, 2800, 3000, 3200, 3466, 3600, 3866, 4000, 4400 MHz These are DDR4 3200 so figured it'd be fine. I didn't see any noticeable performance gains anyway in the short time I was playing with it set to 3200 so I'll probably just keep it at 3000 --- https://i.imgtc.com/MGGa6Os.gif ... Copied to Clipboard!
|
crayola555 03/22/23 11:37:43 AM #4: |
You might also try to change the voltage settings too, might be a cause --- 3DS FC: 0619-4850-3479 IGN: AlmaDelita ... Copied to Clipboard!
|
Jupiter 03/22/23 11:43:49 AM #5: |
Yea you most likely won't notice any difference with those speeds. --- Twitch: https://www.twitch.tv/kid_prodigy23 ... Copied to Clipboard!
|
itachi15243 03/22/23 11:44:40 AM #6: |
Are all your drivers up to date? Bios? Also second this crayola555 posted... You might also try to change the voltage settings too, might be a cause --- I do drawings and stuff https://www.fiverr.com/blueblitz ... Copied to Clipboard!
|
CommonStar 03/22/23 11:45:31 AM #7: |
reset cmos after installing new ram make sure the ram is compatible with your motherboard, check the QVL. ... Copied to Clipboard!
|
MarthGoomba 03/22/23 12:01:18 PM #8: |
XMP is pointless. Just run it stock for better stability --- https://i.imgur.com/m6Rgs8D.jpg https://i.imgur.com/qUMZhdW.jpg https://i.imgur.com/LACtH6q.jpg ... Copied to Clipboard!
|
MedeaLysistrata 03/22/23 12:02:00 PM #9: |
Take a walk to target and ask for information --- Please join the 100 Presidents community board and contribute to the project! Check back for updates! https://gamefaqs.gamespot.com/boards/1568-100-presidents ... Copied to Clipboard!
|
Topic List |
Page List:
1 |